Ten Easy Steps to Professional-Quality Application
1. Patch the area you’re going to texture. (For detailed instructions on patching, click here.) Sand it smooth and wipe any dust away.
2. Make sure to use drop cloths or tape to protect areas like carpet or furniture from any overspray that may occur during application.
3. Shake can well. If can seems cold, warm it up by running it under warm water for about a minute. This helps loosen up the compound and helps ensure an even spray.
4. The Sand nozzle is specially designed to propel Spraytex forward while the can is kept in an upright position. Position your forefinger and middle finger to press down on nozzle. Hold can about 15 to 20 inches away from the wall
5. While moving can in a circular motion, spray short bursts of texture on patch. You may also hold down and continuously spray while keeping the can moving as you spray. Short bursts may make it easier to cover the area you are patching. Always keep nozzle pointed away from your face.
6. Once you’ve achieved your perfect texture match, allow Spraytex to dry for one to four hours, depending on the heaviness of your application.
8. Remember, the lighter the spray, the more coverage you’ll get from the can.
9. Paint! Your patch will have virtually disappeared.
10. For easy cleanup, twist the nozzle off the can and clean with water. Do not turn can upside down and spray to clean nozzle. Spraytex textures clean up with water, even when they’re dry.