Ten Easy Steps to Professional-Quality Application
1. Patch the area you’re going to texture. (For detailed instructions on patching, click here.) Sand it smooth and wipe any dust away.
2. Make sure to use drop cloths or tape to protect areas like carpet or furniture from any overspray that may occur during application.
3. Shake can well. If can seems cold, warm it up by running it under warm water for about a minute. This helps loosen up the compound and helps ensure an even spray.
4. Remove cap and adjust the patented Dial-A-Texture nozzle to achieve desired texture. As you tighten the nozzle, the texture will get heavier. As you loosen the nozzle, the texture gets lighter. Always keep nozzle pointed away from your face.
5. Hold can about 15 to 20 inches away from the wall. Spray using a circular motion over the patch area.
6. Once you’ve achieved your perfect texture match, allow Spraytex to dry for one to four hours, depending on the heaviness of your application. If you are using Quick-Drying Industrial Orangepeel, your dry time will be an hour or less.
8. Remember, the lighter the spray, the more coverage you’ll get from the can.
9. Paint! Your patch will have virtually disappeared.
10. For easy cleanup, twist the nozzle off the can and clean with water. Do not turn can upside down and spray to clean nozzle. Spraytex textures clean up with water, even when they’re dry.